| |
HOW
TO INSTALL HITCH
click
to see an enlargement |
|
| 1. |
Remove
side trunks. |
 |
| 2. |
Remove
bolts (C) on both sides. |
| 3.
|
Remove
bolts (B) on one side only. |
| 4. |
Loosen
bolts (A) |
| 5. |
Swing
back your trunk frame so you can put hitch in place. |
| 6. |
Remove
rubber plug from front of trunk frame. |
| 7. |
Put
hitch between trunk frame and
cycle frame, then put in bolts (C) on both sides. But do not tighten
yet. |
| 8. |
Remove
bolt (A) and drill out thread to 5/16th on both sides then attach
brace with tapped hole to the top. Put behind the frame. Put longer
bolt in which is provided. |
| 9. |
Attach
the end of two braces to the hitch. |
| 10. |
Tighten
all bolts and put trunks back on. |
You will need a 10mm socket, 1/2 inch socket or wrench and a drill and 5/16
inch bit.
Just a few
tips when pulling a trailer behind your motorcycle!
1. The tongue weight
should be between 20 and 30 lbs. IMPORTANT Too much weight on the tongue
will cause the cycle to sag, and too much weight on the rear will cause
the trailer to sway.
2. When pulling a trailer and you are stopping ,give yourself at least
1/3 more stopping time.GET ON THE BRAKES EARLY
3. When pulling your trailer remember your unit is now twice as long as
it was before. When your are passing or going around a corner give yourself
more room.
4. If pulling a trailer for the first time take it easy. Become familiar
with your cycle and trailer combination.
|
