Trailer Hitch

The receiver hitch is 1 inch and comes off with one pin. It mounts without drilling extra holes.

The hitches are made of the top quality steel, by Marv, himself in his shop. When the hitch is completed, it is powder coated which makes them chip & rust restistant and won't scratch. You'll get your money back if you are not fully satisfied.

Products will be shipped by Ground UPS or Parcel Post. All instructions will come with the product. 

We guarantee our products. Your money back if you are not fully satisfied. If the product is faulty in any way it will be replaced. Just return it to us and we will replace it.

This hitch will fit on motorcylces from the years 1986-2003.

*Note: The trailer hitch ball shown in the image above is not included. It can be ordered separately.

Just a few tips when pulling a trailer behind your motorcycle!

1. The tongue weight should be between 20 and 30 lbs. IMPORTANT: Too much weight on the tongue will cause the cycle to sag, and too much weight on the rear will cause the trailer to sway.

2. When pulling a trailer and you are stopping, give yourself at least 1/3 more stopping time. GET ON THE BRAKES EARLY.

3. When pulling your trailer remember your unit is now twice as long as it was before. When your are passing or going around a corner give yourself more room.

4. If pulling a trailer for the first time take it easy. Become familiar with your cycle and trailer combination.

5. Do not exceed the trailer gross weight or the cycle gross weight.